Verine Quasar Plus User Manual download pdf (Page 47)

The fire must only be operated with a fret or fascia as supplied with the product.

which meets the criteria described in the rear of this book.

6.2.1 OPERATING THE FIRE (MANUAL CONTROL MODELS)

The controls are located behind the ashpan cover which is situated behind the

Ashpan / Fender. The controls, comprise a control valve to adjust the gas flow and

a push button piezo igniter. There is also a flame adjuster which slides from left to

right on coal models only. The left hand position gives maximum radiant heat and

output whereas the right hand position gives more flame but slightly less glow. To

light the fire proceed as follows:-

1) Depress the control knob and turn anti-clockwise to the position

marked pilot. Hold in the control knob for a few seconds to allow the gas to

reach the pilot.

2) Continue to hold-in the control knob and press the igniter button. If the pilot

does not light, continue to press the igniter button until ignition occurs. The

pilot flame can be seen by looking at the left hand side front bottom corner of

the glass panel. When the pilot has lit, continue to hold the control knob in

for 5-10 seconds to allow the thermocouple to heat up, if the pilot goes out

when the control knob is released, repeat the lighting sequence.

In the unlikely event of a failure of the igniter, the fire can be lit as follows :-

Remove the fret / ashpan cover, depress the control knob and turn anti-clockwise

to the position marked pilot. Hold in the control knob for a few seconds to allow

the gas to reach the pilot. Insert the tip of a lit taper in behind the front ceramic

rail on the left hand side. This will light the pilot flame. When the pilot has lit,

continue to hold the control knob in for 5-10 seconds to allow the thermocouple to

heat up, if the pilot goes out when the control knob is released, repeat the lighting

sequence.

3) After lighting, turn the control knob in the anti-clockwise direction to the high

position and the main burner will light. For most efficient performance the

fire is allowed to warm up for 10 minutes with the gas control on high.

4) The gas control can be turned clockwise from the maximum position to give

the desired heat output.

WARNING

If the fire goes out for any reason or is turned off and it is

necessary to re-light the fire it is important to allow the fire to cool

for 3 minutes before attempting to re-light it.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 61 62

No comments

Verine Quasar Plus User Manual Page 47